How to Care for Your Hot Tub

Test the Ph and bromine. (Use test strips or kit).

Check Monthly:

Remove and clean the filter with soap and water. Allow the filter to soak overnight in Filter Clean or similar product.

Miscellaneous:

When the water starts to get dirty from extended use, drain the tub. (Make sure the power is off)

1. Drain with a siphon from top of tub or from the spigot located in equipment compartment. Be sure the water is completely drained from the bottom of the tub. You may need to mop the remaining water left in the base of the tub.
2. Clean the tub with Soft Scrub, or similar liquid cleanser. (Note: some household cleaners can create excess suds, so be sure to rinse thoroughly.) Be careful not to overdue the use of any cleansers, as they can dull the finish of your acrylic if used to often or if undue pressure is applied when cleaning. After using liquid cleanser use Spa Fast Gloss to restore the shine to the acrylic.
3. You are now ready to refill the tub. Make sure the power is off, spigot is closed and the valves are open. Fill the tub to 1" on tile (or minimum fill line, whichever is higher).
4. Turn the heat all the way down, turn on power and let the high jets run until water flow is strong. Turn the heat to desired temperature.

Wait until tub is at desired temperature and enjoy!

Your Cart:

You have NO
item(s) in your shopping cart or cookies disabled.